Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 826

2 portShow EXAMPLES ipif iproute arp -lmac vlantag Perm Perm Net App autoneg Displays the IP interface ID, IP address, netmask, and MTU for IPv4 addresses. Displays the prefix instead of the netmask for IPv6 addresses. Flags are explained in the command output (refer to the example below). Displays the IP address, netmask, gateway, metrics, and flags. Displays the prefix instead of the netmask for IPv6 addresses. A status flag for the IP routes indicates if a route is used for the management interfaces. A route definition that uses one of the internal interfaces has the words "Interface Management" printed at the end of the line. Displays the address resolution protocol (ARP) table. You can display the content of the ARP table, but you cannot modify its contents. Displays the local MAC address. This operand is optional. Displays the VLAN Tagging configuration. For each entry, the output displays the IP interface address, the destination IP address, the VLAN ID, the L2 CoS priority, and a flag. This display includes tunnel- and IPIF-level configurations. The following flags indicate the type of configuration: Permanent entry. Permanent entries are configured at the IP interface level with the portCfg vlantag command. Network-wide permanent entry. The same as the permanent entry except that no destination address was defined (defaults to 0.0.0.0), so traffic to all destinations is tagged. Application layer VLAN configuration defined at the circuit level. Displays the atuonegotiation status. To display the IP interface and static route configured on Brocade 7800: switch:admin> portshow ipif ge0 Port: ge0 Interface IPv4 Address NetMask Effective MTU Flags 0 192.168.0.20 255.255.255.0 1500 U R M 1 192.168.0.21 255.255.255.0 1500 U R M Interface IPv6 Address Len Effective MTU Flags 2 fe80::205:1eff:fec3:e6b2 64 1500 U R M 3 2000::20 64 1500 U R M 4 2000::21 64 1500 U R M 5 2000::22 64 1500 U R M Flags: U=Up B=Broadcast D=Debug L=Loopback P=Point2Point R=Running N=NoArp PR=Promisc M=Multicast S=StaticArp LU=LinkUp switch:admin> portshow iproute ge0 798 Fabric OS Command Reference 53-1002746-01