Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1128

2 zone f Enables failover mode. In failover mode, when the last ISL of a TI Zone goes offline and there is an alternative ISL, the alternative ISL is used and the switch does not generate any SCN or RSCN messages. If the ISL of that TI Zone comes online again, traffic is rerouted immediately to the original ISL. name Specifies the name of the zone to be created, added or deleted -p portlist Specifies the lists of ports to be included, added or removed from a TI zone. The syntax for portlist is "D,I" (Domain, Index). The port list must be enclosed in double quotation marks. List members must be separated by semicolons, followed by a space. When you create TI zones over FCR, for a TI within an Edge fabric use "-1"in "I" (of "D,I") in to denote Front and Translate phantom in the E_Port list. When creating a TI zone within the Backbone fabric specify "Port WWN" in portlist to indicate devices talking across fabrics. --activate name Activates the specified TI zones. If more than one zone is specified, the list of zone names must be enclosed in double quotation marks; zone names must be separated by semicolons. --deactivate name Deactivates the specified TI zones. If more than one zone is specified, the list of zone names must be enclosed in double quotation marks; zone names must be separated by semicolons. --delete name Deletes TI zones from the defined TI zone lists. This command prompts for confirmation. --show [name] Displays zone name, port lists, failover option, configured status and, the active status for the specified zones. The configured status reflects the latest change that may or may not have been activated. The active status reflects the state that is activated by cfgEnable. Without any specified name, this command displays all TI zones in the defined configuration. The following operand is optional: -ascending Displays the TI zone members in ascending order. --showTIerrors Analyzes real and potential routing problems with the activated TI zoning set and prints a report. This command must be executed in the local domain and analyzes only that domain. --showTItrunkerrors Displays details of the trunk members present in the TI zone and those not present in the TI zone. 3. Creating and managing RD Zones --rdcreate Creates a RD Zone for the specified members. The following operands are required: host_wwn Specifies the port world wide name of the host. target_wwn Specifies the port world wide name of the target. vi_wwn Specifies the port world wide name of the virtual initiator (VI). 1100 Fabric OS Command Reference 53-1002746-01