Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 421

fmMonitor 2 -port port_list Specifies one or more ports on which to install the monitor for the specified frame type. This operand is optional; if omitted, the monitor is installed on all eligible ports. A port list can consist of the following: • One or more single ports, preceded by a slot number followed by a slash (/) on bladed systems. Multiple ports must be separated by a comma, for example, 8 or 5/8 or 3,5,8. • One or more port ranges where the beginning and end port are separated by a dash, for example, 8-13 or 5/8-13, or 3/4-9. A port range cannot span multiple slots. -highth value Sets the high threshold value for the specified frame monitor. This operand is optional. High threshold values and defaults are platform-specific. Refer to the Fabric Watch Administrator's Guide for more information. -timebase time_base Specifies the time interval between two samples to be compared. Valid intervals include the following: day Samples are compared once a day. hour Samples are compared once every hour. minute Samples are compared once every minute. -action value Specifies the action triggered if the frame count for the specified frame type exceeds the configured high threshold. Valid actions include snmp, raslog, email or none. This operand is optional; if omitted, defaults are used (snmp, raslog). Note that fmMonitor only supports specification of high thresholds and the actions taken when the frame count exceeds the configured high threshold. Use the thConfig command with the filter class operand to configure and display other Fabric Watch thresholds, and the actions to be taken when the counters fall below or in-between configured Fabric Watch thresholds. -nosave Overrides the default behavior, which automatically saves the frame monitor and port configuration persistently when you create, modify, or delete a monitor. When you specify -nosave, the port configuration is not saved and will be erased upon reboot. However, the frame monitor configuration (type, bit pattern, thresholds etc.) will still be saved persistently. This operand is valid only with the --create, --addmonitor, and --delmonitor options. The CFG column in the show command display indicates "not saved" when -nosave is specified; otherwise it indicates "saved". --save frame_type Saves the set of ports on which the specified frame type is monitored to the persistent configuration. If a frame type is not specified, this command saves the port configurations of all existing frame types. This operation removes the configuration for ports not monitored. --addmonitor frame_type -port port_list Installs an existing frame monitor on the specified ports. --delmonitor frame_type -port port_list Removes an existing frame monitor from the specified ports. Fabric OS Command Reference 393 53-1002746-01