Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 359

fcrLsanCount 2 fcrLsanCount Displays or sets the maximum LSAN count. SYNOPSIS fcrlsancount [max_lsan_count] DESCRIPTION NOTES OPERANDS EXAMPLES SEE ALSO Use this command to set or display the maximum number of LSAN zones that can be configured on the edge fabric. By default, the maximum LSAN count is set to 3000, which is also the minimum. This command allows you to create up to 5000 LSANs on your edge fabric, if needed to support additional devices. The maximum number of supported LSAN devices is 10,000. When executed without operand, this command displays the current LSAN zone limit. This command assumes that all FCRs in the same LSAN fabric matrix or backbone have the same maximum LSAN count defined in order to protect the FCRs from running into indefinite state. Asymmetric LSAN configurations due to different maximum LSAN counts may lead to different devices being imported on different FCRs. Because the maximum number of LSANs is configured per switch, if there is a different maximum LSAN count on the switches throughout the meta-SAN, the device import or export will not be identical on the FCRs. You should therefore enter the same maximum LSAN count for all the FCR switches in the same backbone that support this feature. Verify the configured maximum limit against the LSANs configured using the fcrResourceShow command. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: max_lsan_count Specifies the maximum LSAN count. To display the current LSAN limit: switch:admin> fcrlsancount LSAN Zone Limit: 3000 To increase the LSAN zone limit: switch:admin> fcrlsancount 5000 LSAN Zone Limit: 5000 fcrResourceShow Fabric OS Command Reference 331 53-1002746-01