Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 27

- supportSave command output - Detailed description of the problem, including the switch or fabric behavior immediately following the problem, and specific questions - Description of any troubleshooting steps already performed and the results - Serial console and Telnet session logs - syslog message logs • Switch Serial Number The switch serial number and corresponding bar code are provided on the serial number label, as shown here: : *FT00X0054E9 FT00X0054E9 The serial number label is located as follows: - Brocade 300, 5100, 5300, 6505, 6510, 6520, 6547, 7800, 8000, VA-40FC, and Brocade Encryption Switch-On the switch ID pull-out tab located inside the chassis on the port side on the left. - Brocade 5410, 5424, 5430, 5450, 5460, 5470, 5480-Serial number label attached to the module. - DCX, and DCX 8510-8-On the port side of the chassis, on the lower right side and directly above the cable management comb - DCX-4S and DCX 8510-4-On the non-port side of the chassis on the lower left side. • Use the licenseIdShow command to display the switch WWN. If you cannot use the licenseIdShow command because the switch is inoperable, you can get the WWN from the same place as the serial number, except for the Brocade DCX, DCX-4S, DCX 8510-8, and DCX 8510-4. On these models, access the numbers on the WWN cards by removing the Brocade logo plate at the top of the non-port side of the chassis. Document feedback Quality is our first concern at Brocade, and we have made every effort to ensure the accuracy and completeness of this document. However, if you find an error or an omission, or you think that a topic needs further development, we want to hear from you. Forward your feedback to: [email protected] Provide the title and version number and as much detail as possible about your issue, including the topic heading and page number and your suggestions for improvement. Fabric OS Command Reference xxvii 53-1002746-01