Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 498

2 ipAddrShow NOTES OPERANDS EXAMPLES - tentative - preferred - deprecated Refer to the RFC 2462 specification for more information. On modular platforms with intelligent blades, the addresses configured for each slot can be shown with the -slot option. On standalone platforms, all command options are ignored. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: -cp cp_number On dual-CP systems, specifies the CP card number to be displayed (0 or 1). -chassis On dual-CP systems, displays the IP addresses for the chassis. -slot slot Specifies the slot for a blade. -eth0 | -eth1 | -gate For a specified slot, shows only the selected Ethernet interface or the gateway . This operand is optional with the -slot option. To display the IP addresses on a standalone switch: switch:admin> ipaddrshow SWITCH Ethernet IP Address: 10.20.21.204 Ethernet Subnetmask: 255.255.240.0 Gateway IP Address: 10.20.16.1 DHCP: Off IPv6 Autoconfiguration Enabled: Yes Local IPv6 Addresses: dhcpv6 fd00:60:69bc:82:a6f3:568b:a9cc:a149/64 preferred stateless fd00:60:69bc:82:205:33ff:fe94:771f/64 preferred IPv6 Gateways: fe80::21b:edff:fe0b:2400 fe80::21b:edff:fe0b:7800 DHCPv6: On To display all IP addresses on a Brocade DCX backbone: switch:admin> ipaddrshow Chassis Ethernet IP Address: 10.33.60.85 Ethernet Subnetmask: 255.255.240.0 CP0 Ethernet IP Address: 10.33.60.86 Ethernet Subnetmask: 255.255.240.0 Host Name: cp0 Gateway IP Address: 10.33.48.1 CP1 Ethernet IP Address: 10.33.60.87 470 Fabric OS Command Reference 53-1002746-01