Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 983
switch:user>, Blade Type, Status, SW BLADE, ENABLED, is displayed for 16G platforms only with
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 983 highlights
slotShow 2 NOTES OPERANDS EXAMPLES DISABLED FAULTY UNKNOWN The blade is powered on but disabled. The blade is faulty because an error was detected. A fault code of 53 may also indicate the possibility of a rolling reboot detection (RRD) on the specified blade. In the case of an RRD, investigate and correct the cause, then reboot the control processor (CP) to recover the blade. The blade is inserted but its state cannot be determined. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. In a DCX-4S, slot 5 is occupied by a control processor blade (Blade ID 50). On a DCX, slot 5 is occupied by the core blade (Blade ID 52). This command supports the following operands: -p In addition to the basic slot status view, displays the following information about power consumption: • Total direct current (DC) power consumption for the chassis and individual values for each blade (in Watts). Usage for other components such the WWN card or fans is included in the calculation but not listed per component. Note that the data displayed in the "DC Power Consumption" column and in the summary field "Total DC Power consumption" indicate the maximum allowed power consumption, not a real-time value. Real-time power consumption data is displayed for 16G platforms only with the chassisShow command. • Total alternating current (AC) power consumption in Watts. This value indicates the maximum allowed AC power consumption; it is not a real-time value. • AC efficiency, as a percentage of total and BTU. • Power efficiency in Watts/port and Watts/Gb. -m In addition to the basic slot status view, displays the Brocade model name for each blade. To display the status of all slots on a DCX 8510-8: switch:user> slotshow Slot Blade Type ID Status 1 SW BLADE 97 ENABLED 2 SW BLADE 96 ENABLED 3 SW BLADE 97 ENABLED 4 SW BLADE 96 ENABLED 5 CORE BLADE 98 ENABLED 6 CP BLADE 50 ENABLED 7 CP BLADE 50 ENABLED 8 CORE BLADE 98 ENABLED 9 SW BLADE 125 ENABLED 10 SW BLADE 126 ENABLED 11 SW BLADE 37 ENABLED 12 SW BLADE 55 ENABLED Fabric OS Command Reference 955 53-1002746-01