Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 621

perfAddEEMonitor 2 OPERANDS EXAMPLES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: slot For bladed systems only, specifies the slot number of the port on which the monitor is to be added, followed by a slash (/). port Specifies the number of the port on which the monitor is to be added, relative to its slot for bladed systems. Use switchShow for a list of valid ports. SourceID Specifies the 3-byte SID (Source ID) of the originator device. It should be in "0xDDAAPP" format, where DD is domain ID, AA is area ID and PP is AL_PA ID. For example, 0x050200 has a domain ID of 5, an area ID of 2, and an AL_PA ID of 0. SourceID and DestID both cannot be 0x000000. DestID Specifies the 3-byte DID (destination ID) of the destination device. It should be in "0xDDAAPP" format, where DD is domain ID, AA is area ID and PP is AL_PA ID. For example, 0x050200 has a domain ID of 5, an area ID of 2, and an AL_PA ID of 0. SourceID and DestID both cannot be 0x000000. -force Overrides a hardware limitation that does not allow incompatible monitors to coexist on the same ASIC chip. To add an end-to-end monitor to blade 1 port 2: switch:admin> perfaddeemonitor 1/2 0x050200 0x1182ef End-to-End monitor number 0 added. To add an end-to-end monitor to an Encryption switch ( In this scenario, one target disk storage device connects to the Encryption switch, and an initiator device connects to a DCX backbone. The DCX is directly connected to the Encryption Switch. Two EE monitors are added on port 1 of the Encryption Switch, which is an F_Port that attaches to the target device): 1. Get the CryptoTarget container configuration. This command shows the PIDs for the target, the virtual target, the initiator, and the virtual initiator: EncryptionSwitch:Securityadmin> cryptocfg --show \ -container -all -stat Encryption group name: brcd Number of Container(s): 1 Container name: st_target Type: disk EE node: 10:00:00:05:1e:53:b8:45 EE slot: 0 Target: 2f:ff:00:06:2b:0e:b3:3c \ 2f:ff:00:06:2b:0e:b3:3c Target PID: 0a0100 VT: 20:00:00:05:1e:53:b8:41 \ 20:00:00:05:1e:53:b8:41 VT PID: 0a2001 Number of host(s): 1 Number of rekey session(s): 0 Host: 10:00:00:00:c9:52:00:7d \ Fabric OS Command Reference 593 53-1002746-01