Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 176

2 configShow configShow Displays system configuration settings. SYNOPSIS configshow configshow [-all | -fid FID | -chassis | -switch] | [-local | -USB | -U] [file] [-pattern "pattern"] DESCRIPTION NOTES OPERANDS Use this command to display system configuration settings. Some but not all of these parameters are set by the configure and configureChassis commands. Configuration data is grouped into chassis information and switch information. Each configuration type is managed separately. The behavior of configShow depends on the environment in which the command is executed: • In a Virtual Fabric environment, when executed without operands, this command displays the switch configuration for the current logical switch. An Admin with chassis permissions can use additional parameters to display configuration data for a specified logical switch (-fid FID), for the chassis (-chassis), or for all logical switches and the chassis (-all). • In a non-Virtual Fabric environment, when executed without operands, this command displays the switch configuration. When executed with the -all operand, configShow displays all of the system's configuration data, including chassis and switch configuration data. The -chassis option displays the chassis configuration only. The -switch option displays the switch configuration only. The -fid option is not valid. Not all values displayed are applicable to all system models and configurations. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. The following operands are optional: -pattern "pattern" Specifies a text string, enclosed in double quotation marks, that limits the output of the command to only those entries that contain the pattern. Use of wildcards and other common regular expression operators is not supported. Some configuration settings do not display when filtered. When in doubt, use the command without the -pattern operand. Executing configShow -pattern without further operands is not recommended and can cause unspecified behavior. -all Displays all configuration data including chassis and switch configuration. -fid FID Displays configuration data for a logical switch specified by its fabric ID. This option is valid only in a Virtual Fabric environment and requires chassis permissions -chassis Displays configuration data for the chassis only. This option is valid only in a Virtual Fabric environment and requires chassis permissions -switch Displays the switch configuration only. This option is valid only in a Non-Virtual Fabric environment. 148 Fabric OS Command Reference 53-1002746-01