Netgear XCM8810 Chassis Hardware Installation Guide - Page 1014
con ospf spf-hold-time
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1014 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Configures the OSPF router ID. If automatic is specified, the switch uses the highest IP interface address as the OSPF router ID. Syntax Description automatic router-identifier Specifies to use automatic addressing. Specifies a router address. Default Automatic. Usage Guidelines Each switch that is configured to run OSPF must have a unique router ID. It is recommended that you manually set the router ID of the switches participating in OSPF, instead of having the switch automatically choose its router ID based on the highest interface IP address. Not performing this configuration in larger, dynamic environments could result in an older link-state database remaining in use. Note: Do not set the router ID to 0.0.0.0. Example The following command sets the router ID: configure ospf routerid 10.1.6.1 configure ospf spf-hold-time configure ospf spf-hold-time Description Configures the minimum number of seconds between Shortest Path First (SPF) recalculations. Syntax Description seconds Specifies a time in seconds. The range is 0 to 300 seconds. 1014 | Chapter 23. OSPF Commands