Netgear XCM8810 Chassis Hardware Installation Guide - Page 772
create stpd, Rapid Root Failover-disabled
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 772 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command adds slot 1, port 2 and slot 2, port 3, members of a VLAN named Marketing, to the STPD named STPD1, and specifies that they be in EMISTP mode: configure vlan marketing add ports 1:2, 2:3 tagged stpd stpd1 emistp create stpd create stpd Description Creates a user-defined STPD. Syntax Description stpd_name Specifies a user-defined STPD name to be created. May be up to 32 characters in length. Default The default device configuration contains a single STPD called s0. When an STPD is created, the STPD has the following default parameters: • State-disabled • StpdID-none • Assigned VLANs-none • Bridge priority-32,768 • Maximum BPDU age-20 seconds • Hello time-2 seconds • Forward delay-15 seconds • Operational mode-802.1D • Rapid Root Failover-disabled • Default Binding Mode (encapsulation mode)-Ports in the default STPD (s0) are in 802.1d mode. Ports in user-created STPDs are in emistp mode. • Maximum hop count (when configured for MSTP)-20 hops Usage Guidelines The maximum length for a name is 32 characters. Names can contain alphanumeric characters and underscores ( _ ) but cannot be any reserved keywords, for example, stp or stpd. Names must start with an alphabetical character, for example, a, Z. For name creation guidelines and a list of reserved names, see the section "Object Names" in the NETGEAR 8800 User Manual. 772 | Chapter 17. STP Commands