Netgear XCM8810 Chassis Hardware Installation Guide - Page 96
con telnet vr, specifies the name of the virtual router to use for Telnet connections.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
NETGEAR 8800 Chassis Switch CLI Manual configure telnet port 85 The following command returns the port used for Telnet to the default port of 23: configure telnet port default configure telnet vr configure telnet vr [all | default | ] Description Configures the virtual router used on the switch for listening for Telnet connections. Syntax Description all default vr_name Specifies to use all virtual routers for Telnet connections. Specifies to use the default virtual router for Telnet connections. The default router is VR-Mgmt. Specifies the name of the virtual router to use for Telnet connections. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A of the NETGEAR 8800 User Manual. Default The default is all. Usage Guidelines You must be logged in as administrator to configure the virtual router. The switch accepts IPv6 connections. If you specify all, the switch listens on all of the available virtual routers for Telnet connections. The vr_name specifies the name of the virtual router to use for Telnet connections. If you specify a virtual router name that does not exist, the switch displays an error message similar to the following: configure telnet vr vr-ttt ^ %% Invalid input detected at '^' marker. Example The following command configures the switch to listen for and receive Telnet requests on all virtual routers: 96 | Chapter 3. Commands for Managing the Switch