Netgear XCM8810 Chassis Hardware Installation Guide - Page 703
Network Login Commands, NETGEAR 8800 Chassis Switch CLI Manual, network login
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 703 highlights
NETGEAR 8800 Chassis Switch CLI Manual NetLogin port mode: Smart redundancy: Software redundant port: auto-polarity: MAC based VLANs Enabled Disabled Enabled The added output displays information about the mode of operation for the network login port. • VLAN cfg-The term MAC-based appears next to the tag number. • Netlogin port mode-This output was added to display the port mode of operation. Mac based appears as the network login port mode of operation. To view information about the ports that are temporarily added in MAC-based mode for network login, due to discovered MAC addresses, use the following command: show vlan detail The following is sample output from this command: VLAN Interface with name Default created by user Tagging: 802.1Q Tag 1 Priority: 802.1P Priority 0 Virtual router: VR-Default STPD: s0(Disabled,Auto-bind) Protocol: Match all unfiltered protocols Loopback: Disable NetLogin: Disabled Rate Shape: Disabled QosProfile: None configured Ports: 26. (Number of active ports=2) Untag: *1um, *2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, 25, 26 Flags: (*) Active, (!) Disabled, (g) Load Sharing port (b) Port blocked on the vlan, (a) Authenticated NetLogin Port (u) Unauthenticated NetLogin port, (m) Mac-Based port The flags associated with network login include: • a-Indicates an authenticated network login port. • u-Indicates an unauthenticated network login port. • m-Indicates that the network login port operates in MAC-based mode. Example The following command configures the network login ports mode of operation: configure netlogin ports 1:1-1:10 mode mac-based-vlans Chapter 16. Network Login Commands | 703