Netgear XCM8810 Chassis Hardware Installation Guide - Page 259

NETGEAR 8800 Chassis Switch CLI Manual Port Temp TxPower RxPower TxBiasCurrent Voltage-Aux1 Voltage-Aux2 (Celcius) (dBm) (dBm) (mA) (Volts) (Volts) 1:1 30.60 -25.20 -18.70 0.40 5.09 5.07 1:2 30.60 -25.20 -18.70 0.40 5.09 N/A N/A indicates that the parameter is not applicable to the optics connected to the port show port transceiver information detail show port transceiver information detail Description Displays detailed information about the optical transceiver. Syntax Description port-list Specifies the port number(s). Default N/A. Usage Guidelines Digital Diagnostic Monitoring Interface (DDMI) provides critical system information about 10G XFP optical modules. Use this command to monitor the condition of the XFP modules. If you try to execute this command on one of the ports in the port list that is non-compliant with DDMI, the following error message is displayed and the command does not go through: Port 3:1 This command is not supported on this port. All ports and transceiver of the ports requested in the command need to support DDMI. If you try to execute this command on one of the ports in the port list on which the transceiver is non-compliant with DDMI, the following error message is displayed: Port 3:1 This media/transceiver does not support enhanced digital diagnostic monitoring interface (DDMI). All ports and transceiver of the ports requested in the command need to support DDMI. Example The following display shows output for the command show port 1:1-2 transceiver information detail: BD-8810.2 # sh port 1:1 transceiver information detail Port : 1:1 Chapter 5. Commands for Configuring Slots and Ports on a Switch | 259