Netgear XCM8810 Chassis Hardware Installation Guide - Page 1236
The following command displays the elected, active RP for the group 239.255.255.1
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1236 highlights
NETGEAR 8800 Chassis Switch CLI Manual Source Specific Multicast : Disabled State Refresh : On State Refresh Capable : Yes Border : No Neighbor IP address Generation Id 36.36.36.6 0x4a01a39d Expires State Refresh 90 On Packet Statistics (In/Out) Hellos 20 20 Bootstraps 0 0 Join/Prunes 0 0 Asserts 0 0 Grafts 0 0 GraftAcks 0 0 State Refresh 0 0 The following command displays the elected, active RP for the group 239.255.255.1: show pim rp-set 239.255.255.1 Group Mask C-RP Origin Priority 224.0.0.0 240.0.0.0 10.10.10.2 Bootstrap 0 224.0.0.0 240.0.0.0 124.124.124.124 Bootstrap 0 224.0.0.0 240.0.0.0 124.124.124.124 static 0 239.255.255.0 255.255.255.0 124.124.124.124 Bootstrap 0 Elected RP is 124.124.124.124 The following command displays the PIM configuration for VLAN v36: Switch.12 # show pim vlan v36 PIM DENSE Interface[2] on VLAN v36 is enabled and up IP adr: 36.36.36.3 mask: 255.255.0.0 DR of the net: 36.36.36.6 Passive : No Hello Interval : 30 sec Neighbor Time out : 105 sec Join/Prune Interval : 60 sec Join/Prune holdtime : 210 sec Trusted Gateway : none CRP group List : none with priority 0 Shutdown priority : 1024 Source Specific Multicast : Disabled State Refresh : On State Refresh Capable : Yes Border : No Neighbor IP address Generation Id Expires StateRefresh 36.36.36.6 0x4a01a39d 95 On Packet Statistics (In/Out) Hellos 33 32 Bootstraps 0 0 Join/Prunes 0 0 Asserts 0 0 Grafts 0 0 GraftAcks 0 0 1236 | Chapter 26. IP Multicast Commands