Netgear XCM8810 Chassis Hardware Installation Guide - Page 1208
enable igmp snooping vlan fast-leave, mode to
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1208 highlights
NETGEAR 8800 Chassis Switch CLI Manual Note: The forward-mcrouter-only mode for IGMP snooping is enabled/disabled on a switch-wide basis, not on a per-VLAN basis. In other words, all the interfaces enabled for IGMP snooping are either in the forward-mcrouter-only mode or in the non-forward-mcrouter-only mode, and not a mixture of the two modes. To change the snooping mode you must disable IP multicast forwarding. To disable IP multicast forwarding, use the command: disable ipmcforwarding {vlan } To change the IGMP snooping mode from the non-forward-mcrouter-only mode to the forward-mcrouter-only mode, use the commands: disable ipmcforwarding enable igmp snooping forward-mcrouter-only enable ipmcforwarding (vlan } To change the IGMP snooping mode from the forward-mcrouter-only mode to the non-forward-mcrouter-only mode, use the commands: disable ipmcforwarding disable igmp snooping forward-mcrouter-only enable ipmcforwarding (vlan } Example The following command enables IGMP snooping on the switch: enable igmp snooping enable igmp snooping vlan fast-leave enable igmp snooping {vlan} fast-leave Description Enables the IGMP snooping fast leave feature on the specified VLAN. Syntax Description name Specifies a VLAN. Default Disabled. 1208 | Chapter 26. IP Multicast Commands