Netgear XCM8810 Chassis Hardware Installation Guide - Page 253
The link filter counter displayed with
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
NETGEAR 8800 Chassis Switch CLI Manual If you do not specify a port number or range of ports, detailed system-related information is displayed for all ports. The data is displayed in a table format. This status information may be useful for your technical support representative if you have a network problem. The detail parameter is used to provided more specific port information. The data is called out with written explanations versus displayed in a table format. Note: The keyword detail displays slightly different information depending on the platform and configuration you are working with. The link filter counter displayed with the detail keyword is calculated at the middle layer on receiving an event. The link filter up indicates the number of link transitions from down to up at the middle layer filter. Example The following command displays port system-related information on a NETGEAR 8810 switch: show port 1:1 info Following is sample output from this command: * XCM8806.1 # show port 1:1 info Port Flags Link OAM Link Num Num Num Jumbo QOS Load State UPS STP VLAN Proto Size profile Master 1:1 Em---------fMB---x ready -/- 0 1 1 1 9216 none > indicates Port Display Name truncated past 8 characters Flags : a - Load Sharing Algorithm address-based, D - Port Disabled, E - Port Enabled, g - Egress TOS Enabled, j - Jumbo Frame Enabled, l - Load Sharing Enabled, m - MACLearning Enabled, n - Ingress TOS Enabled, o - Dot1p Replacement Enabled, P - Software redundant port(Primary), R - Software redundant port(Redundant), q - Background QOS Monitoring Enabled, s - diffserv Replacement Enabled, v - Vman Enabled, f - Unicast Flooding Enabled, M - Multicast Flooding Enabled, B - Broadcast Flooding Enabled O - Ethernet OAM Enabled w - MACLearning Disabled with Forwarding b - Rx and Tx Flow Control Enabled, x - Rx Flow Control Enabled Chapter 5. Commands for Configuring Slots and Ports on a Switch | 253