Netgear XCM8810 Chassis Hardware Installation Guide - Page 366
Displaying the Module Recovery Setting, Table 10.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 366 highlights
NETGEAR 8800 Chassis Switch CLI Manual Table 10. Module Recovery Actions for the NETGEAR 8800 Series Switches (Continued) Module Recovery Setting Hardware Single MSM Dual MSM I/O Module shutdown Single MSM Dual MSM I/O Module Action Taken Resets the MSM. Resets the primary MSM and fails over to the backup MSM. Resets the I/O module a maximum of five times. After the fifth time, the I/O module is permanently taken offline. The MSM is available for debugging purposes only (the I/O ports also go down); however, you must clear the shutdown state using the clear sys-recovery-level command for the MSM to become operational. After you clear the shutdown state, you must reboot the switch. For more information see the clear sys-recovery-level command. The MSM is available for debugging purposes only (the I/O ports also go down); however, you must clear the shutdown state using the clear sys-recovery-level command for the MSM to become operational. After you clear the shutdown state, you must reboot the switch. For more information see the clear sys-recovery-level command. Reboots the I/O module. When the module comes up, the ports remain inactive because you must clear the shutdown state using the clear sys-recovery-level command for the I/O module to become operational. After you clear the shutdown state, you must reset each affected I/O module or reboot the switch. For more information see the clear sys-recovery-level command. Displaying the Module Recovery Setting To display the module recovery setting, use the following command: show slot The show slot output has been modified to include the shutdown configuration. If you configure the module recovery setting to shutdown, the output displays an "E" flag that indicates any errors detected on the slot disables all ports on the slot. The "E" flag appears only if you configure the module recovery setting to shutdown. 366 | Chapter 8. Commands for Status Monitoring and Statistics