Netgear XCM8810 Chassis Hardware Installation Guide - Page 693
con netlogin dynamic-vlan
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 693 highlights
NETGEAR 8800 Chassis Switch CLI Manual • supp-resp-timeout-ERROR: Supplicant response timeout out of range (1..120 sec) To display the 802.1x timer settings, use the show netlogin and show netlogin dot1x commands. Example The following command changes the 802.1x server-timeout to 10 seconds: configure netlogin dot1x timers server-timeout 10 configure netlogin dynamic-vlan configure netlogin dynamic-vlan [disable | enable] Description Configures the switch to automatically and dynamically create a VLAN after receiving authentication requests from one or more supplicants (clients). Syntax Description disable enable Specifies that the switch does not automatically create dynamic VLANs. This is the default behavior. Specifies that the switch automatically create dynamic VLANs. Default The default is disabled. Usage Guidelines Use this command to configure the switch to dynamically create a VLAN. If configured for dynamic VLAN creation, the switch automatically creates a supplicant VLAN that contains both the supplicant's physical port and one or more uplink ports. A dynamically created VLAN is only a Layer 2 bridging mechanism; this VLAN does not work with routing protocols to forward traffic. After the switch unauthenticates all of the supplicants from the dynamically created VLAN, the switch deletes that VLAN. Note: Dynamically created VLANs do not support the session refresh feature of web-based network login because dynamically created VLANs do not have an IP address. Also, dynamic VLANs are not supported on ports when STP and network login are both configured on the ports. Chapter 16. Network Login Commands | 693