Netgear XCM8810 Chassis Hardware Installation Guide - Page 522
Default, Usage Guidelines, Table 16, Example, Description, con dot1p replacement
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 522 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines Note: NETGEAR recommends that you use the qosprofile value to configure this parameter. Egress packets contain the DSCP assigned to the QoS profile, which is can be selected by the 802.1p code point or by an ACL. The default 802.1p priority value to QoS profile to DSCP mapping is shown in Table 16. Table 16. Default QoS Profile-to-802.1p Priority Value-to-Code Point 802.1p Priority Value NETGEAR 8800 Switches QoS Profile 0 QP1 1 QP1 2 QP1 3 QP1 4 QP1 5 QP1 6 QP1 7 QP8 DSCP 0 8 16 24 32 40 48 56 Example The following command specifies that a code point value of 5 should be used to replace the DiffServ (TOS) bits in packets in QP2: configure diffserv replacement qosprofile qp2 code-point 5 configure dot1p replacement configure dot1p replacement {qosprofile} priority {ports } Description Configures an 802.1p priority replacement configuration to override the 802.1p priority value configured for the specified QoS profile on the specified ports. 522 | Chapter 14. QoS Commands