Netgear XCM8810 Chassis Hardware Installation Guide - Page 213

NETGEAR 8800 Chassis Switch CLI Manual If you attempt to enter a port number that is different that a LAG group ID, the system returns the following error message: ERROR: LAG group Id does not exist Note: To force the LACP trunk to behave like a static sharing trunk, use this command to add ports to the aggregator. Example The following command deletes defaulted ports from the aggregator for the specified LAG group ID: configure sharing 5:1 lacp defaulted-state-action delete configure sharing lacp system-priority configure sharing lacp system-priority Description Configures the system priority used by LACP for each LAG to establish the station on which end assumes priority in determining those LAG ports moved to the collecting/distributing state of the protocol. That end of the LAG with the lowest system priority is the one that assumes control of the determination. This is optional; if you do not configure this parameter, LACP uses system MAC values to determine priority. If you choose to configure this parameter, enter a value between 1 and 65535. Syntax Description port priority Specifies the master logical port for the LAG you are setting the priority for. Enter the value you want for the priority of the system for the LACP. The range is 1 to 65535; there is no default. Default N/A. Usage Guidelines The LACP uses the system MAC values to assign priority to one of the systems, and that system then determines which LAG ports move into the collecting/distributing state and exchange traffic. That end of the LAG with the lowest system priority is the one that assumes control of the determination. If you wish to override the default LACP system priority for a specific LAG, use this command to assign that LAG a specific LACP priority. Enter a value between 1 and 65535. You must enable sharing and create the LAG prior to assigning this LACP priority. Chapter 5. Commands for Configuring Slots and Ports on a Switch | 213