Netgear XCM8810 Chassis Hardware Installation Guide - Page 368
Troubleshooting Module Failures, Example, Description, con syslog add
![]() |
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 368 highlights
NETGEAR 8800 Chassis Switch CLI Manual Flags: Restart count: Serial number: Hw Module Type: SW Version: SW Build: Configured Type: Ports available: Recovery Mode: M 0 (limit 5) 800421-00 00000000000 XCM8848T(P) 12.4.4.0 v1244b0-br-SR3-1 XCM8848T(P) 48 Reset Flags : M - Backplane link to Master is Active B - Backplane link to Backup is also Active D - Slot Disabled, S - Slot Secured I - Insufficient Power (refer to "show power budget") Troubleshooting Module Failures If you experience an I/O module failure, use the following troubleshooting methods when you can bring the switch offline to solve or learn more about the problem: • Restarting the I/O module-Use the disable slot command followed by the enable slot command to restart the offending I/O module. By issuing these commands, the I/O module and its associated fail counter is reset. If the module does not restart, or you continue to experience I/O module failure, please contact NETGEAR Technical Support. • Running diagnostics-Use the run diagnostics normal command to run operational diagnostics on the offending I/O module to ensure that you are not experiencing a hardware issue. If the module continues to enter the failed state, please contact NETGEAR Technical Support. If you experience an MSM/MM failure, please contact NETGEAR Technical Support. Example The following command configures a switch to not take an action if a hardware fault occurs: configure sys-recovery-level slot none configure syslog add configure syslog add [ | ] {vr } [local0 ... local7] {} Description Configures the remote syslog server host address, and filters messages to be sent to the remote syslog target. 368 | Chapter 8. Commands for Status Monitoring and Statistics
![](/manual_guide/products/netgear-xcm8806-chassis-hardware-installation-guide-da290e3/368.png)