Netgear XCM8810 Chassis Hardware Installation Guide - Page 199
con mirroring delete, VLAN where
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
NETGEAR 8800 Chassis Switch CLI Manual IP multicast packets which are egress mirrored contain the source MAC address and VLAN ID of the unmodified packet. • Enhanced mirroring mode must be configured if you are going to configure a remote mirroring tag. Enhanced mirroring mode is configured using the following command: configure mirroring mode enhanced • The configuration of remote-tag does not require the creation of a VLAN with the same tag; on these platforms the existence of a VLAN with the same tag as a configured remote-tag is prevented. This combination is allowed so that an intermediate remote mirroring switch can configure remote mirroring using the same remote mirroring tag as other source switches in the network. Make sure that VLANs meant to carry normal user traffic are not configured with a tag used for remote mirroring. • When a VLAN is created with remote-tag, that tag is locked and a normal VLAN cannot have that tag. The tag is unique across the switch. Similarly if you try to create a remote-tag VLAN where remote-tag already exists in a normal VLAN as a VLAN tag, you cannot use that tag and the VLAN creation fails. Example The following example sends all traffic coming into a NETGEAR 8800 series switch on slot 3, port 2 to the mirror port: configure mirroring add port 3:2 ingress configure mirroring delete configure mirroring delete [all | port {vlan } |vlan {port }] Description Deletes a particular mirroring filter definition on the switch. Syntax Description all port port vlan name Specifies all mirroring filter definitions. Specifies a port or a slot and port. Specifies particular ports or slots and ports. Specifies a VLAN. Specifies a VLAN name. Default N/A. Chapter 5. Commands for Configuring Slots and Ports on a Switch | 199