Netgear XCM8810 Chassis Hardware Installation Guide - Page 423
Default, Usage Guidelines, Host Name and Remote IP Address Character Restrictions
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 423 highlights
NETGEAR 8800 Chassis Switch CLI Manual only regex chronological Specifies that only the specified severity level is to be displayed. Specifies a regular expression. Only messages that match the regular expression will be displayed. Specifies uploading log messages in ascending chronological order (oldest to newest). Default The following defaults apply: • messages-memory buffer • severity-none (displays everything stored in the target) • match-no restriction • chronological-if not specified, show messages in order from newest to oldest Usage Guidelines This command is similar to the show log command, but instead of displaying the log contents on the command line, this command saves the log to a file on the TFTP server you specify. For more details on most of the options of this command, see the command show log on page 387. Host Name and Remote IP Address Character Restrictions This section provides information about the characters supported by the switch for host names and remote IP addresses. When specifying a host name or remote IP address, the switch permits only the following characters: • Alphabetical letters, upper case and lower case (A-Z, a-z) • Numerals (0-9) • Period ( . ) • Dash ( - ) Permitted only for host names • Underscore ( _ ) Permitted only for host names • Colon ( : ) When naming or configuring an IP address for your network server, remember the requirements listed above. Remote Filename Character Restrictions This section provides information about the characters supported by the switch for remote filenames. When specifying a remote filename, the switch permits only the following characters: • Alphabetical letters, upper case and lower case (A-Z, a-z) Chapter 8. Commands for Status Monitoring and Statistics | 423