Netgear XCM8810 Chassis Hardware Installation Guide - Page 532
G I/O module
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 532 highlights
NETGEAR 8800 Chassis Switch CLI Manual port_list all Specifies a list of slots and ports to which the parameters apply. Specify ports using the following formats: 3-5, 2:5, 2:6-2:8. Specifies this applies to all ports on the device. Default Disabled by default. • Minimum bandwidth-0% • Maximum bandwidth-100% • Priority-By default, each qosprofile is assigned a different priority level, which varies by I/O module: • 1G I/O module: • IQP1 - 1, Low • IQP2 - 2, LowHi • 10G I/O module: • IQP1 - 1, Low • IQP2 - 2, LowHi • IQP3 - 3, Normal • IQP4 - 4, NormalHi • IQP5 - 5, Medium • IQP6 - 6, MediumHi • IQP7 - 7, High • IQP8 - 8, HighHi (highest priority) Usage Guidelines The number of ingress queues per port varies between the 1G I/O module and the 10G module. On the 1G module, you have two ingress queues per port. The priority values of 1 to 4 map to the first queue, and the priority values of 5 to 8 map to the second queue. On the 10G module, you have eight ingress queues per port. The priority values of 1 to 8 map one to each of the eight queues. Example The following command configures the ingress rate shaping parameters of QoS profile IQP3 for specified ports, using bandwidth percentages: configure qosprofile ingress iqp3 minbw 27 maxbw 57 priority 4 ports 3:2 The following command configures the ingress rate shaping parameters for QoS profile IQP3 for all ports, using absolute values for committed rate and peak rate: 532 | Chapter 14. QoS Commands