Netgear XCM8810 Chassis Hardware Installation Guide - Page 403

NETGEAR 8800 Chassis Switch CLI Manual STP InBPDU Trace Debug-Verbose 2 total 0 - string 1 - string (printf) Port=%0%: %1% show ports rxerrors show ports {} rxerrors {no-refresh} Description Displays real-time receive error statistics. The switch automatically refreshes the output unless otherwise specified. Syntax Description port_list no-refresh Specifies one or more ports or slots and ports. Specifies that auto-refresh is disabled. The output provides a real-time snapshot of the receive errors at the time the command is issued. This setting is not saved. Default The switch automatically refreshes the output. Usage Guidelines If you do not specify a port number or range of ports, receive error statistics are displayed for all ports. If you do not specify the no-refresh parameter, the switch automatically refreshes the output (this is the default behavior). If you specify the no-refresh parameter, the output provides a snapshot of the real-time receive error statistics at the time you issue the command and displays the output in page-by-page mode. This setting is not saved; therefore you must specify the no-refresh parameter each time you want a snapshot of the port receive errors. This status information may be useful for your technical support representative if you have a network problem. Collected Port Receive Error Information The switch collects the following port receive error information: • Port Number • Link State-The current state of the link. Options are: • Active (A)-The link is present at this port. Chapter 8. Commands for Status Monitoring and Statistics | 403