Netgear XCM8810 Chassis Hardware Installation Guide - Page 520
QoS Commands
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 520 highlights
14. QoS Commands 14 This chapter describes commands for: • Configuring Quality of Service (QoS) profiles • Creating traffic groupings and assigning the groups to QoS profiles • Configuring, enabling, and disabling explicit class-of-service traffic groupings (802.1p and DiffServ) • Configuring traffic grouping priorities • Metering using ACLs • Verifying configuration and performance • Egress traffic rate limiting For an introduction to QoS features, see the NETGEAR 8800 User Manual. configure diffserv examination code-point qosprofile The syntax is: configure diffserv examination code-point {qosprofile} Description Configures the default ingress DiffServ code point (DSCP) to QoS profile mapping. Syntax Description code-point qosprofile Specifies a DiffServ code point (a 6-bit value in the IP-TOS byte in the IP header). Supported values are 0 to 63. Specifies the QoS profile to which the DiffServ code point is mapped. Default See Table 15. Chapter 14. QoS Commands | 520