Netgear XCM8810 Chassis Hardware Installation Guide - Page 78

NETGEAR 8800 Chassis Switch CLI Manual Syntax Description hex_addr_name addr_name hex_param_name param_name ip_address ip_and_tmask ipv6_address ipv6_and_tmask port_number src_ip_address src_ipv6_address vr_name tag-list volatile Specifies a string identifier for the target address. The value is to be supplied as a colon separated string of hex octets. Specifies a string identifier for the target address in ASCII format. Specifies the parameter name associated with the target. The value is to be supplied as a colon separated string of hex octets. Specifies the parameter name associated with the target in ASCII format. Specifies an SNMPv3 target IPv4 address. Specifies the IPv4 address and hexadecimal mask in form A.B.C.D/NN... Specifies an SNMPv3 target IPv6 address. Specifies an IPv6 address and hexadecimal mask in form A:B:C:D:E:F:G:H/NN... Specifies a UDP port. Default is 162. Specifies the IPv4 address of a VLAN to be used as the source address for the trap. Specifies the IPv6 address of a VLAN to be used as the source address for the trap. Specifies the name of the virtual router. Specifies a list of comma separated string identifiers for the notifications to be sent to the target. Specifies volatile storage. By specifying volatile storage, the configuration is not saved across a switch reboot. Default The default values are: • transport-port-port 162 • non-volatile storage If you do not specify tag-list the single tag defaultNotify, a pre-defined value in the snmpNotifyTable, is used. Usage Guidelines Use this command to create an entry in the SNMPv3 snmpTargetAddressTable. The param parameter associates the target address with an entry in the snmpTargetParamsTable, which specifies security and storage parameters for messages to the target address, and an entry in the snmpNotifyFilterProfileTable, which specifies filter profiles to use for notifications to the target address. The filter profiles are associated with the filters in the snmpNotifyFilterTable. 78 | Chapter 3. Commands for Managing the Switch