Netgear XCM8810 Chassis Hardware Installation Guide - Page 1244
con mld snooping vlan ports add static group, IPv6 Multicast Commands
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1244 highlights
NETGEAR 8800 Chassis Switch CLI Manual • last member query interval-1 second • robustness-2 Usage Guidelines Timers are based on RFC2710. Specify the following: • query interval-The amount of time, in seconds, the system waits between sending out general queries. The range is 1 to 429,496,729 seconds. • query response interval-The maximum response time inserted into the periodic general queries. The range is 1 to 25 seconds. • last member query interval-The maximum response time inserted into a group-specific query sent in response to a leave group message. The range is 1 to 25 seconds. • robustness-The degree of robustness of the network. The range is 2 to 7. Example The following command configures the MLD timers: configure mld 100 5 1 3 configure mld snooping vlan ports add static group configure mld snooping {vlan} ports add static group Description Configures VLAN ports to receive the traffic from a multicast group, even if no MLD joins have been received on the port. Syntax Description vlanname portlist v6grpipaddress Specifies a VLAN name. Specifies one or more ports or slots and ports. On a modular switch, it can be a list of slots and ports. On a stand-alone switch, it can be one or more port numbers. In the form 1, 2, 3-5, 2:5, 2:6-2:8. Specifies the multicast group IPv6 address. Default None. Usage Guidelines Use this command to forward a particular multicast group to VLAN ports. In effect, this command emulates a host on the port that has joined the multicast group. As long as the port is configured with the static entry, multicast traffic for that multicast group is forwarded to that port. 1244 | Chapter 27. IPv6 Multicast Commands