Netgear XCM8810 Chassis Hardware Installation Guide - Page 302
con inline-power disconnect-precedence
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default 50 W. Usage Guidelines This command sets the budgeted power reserved for all PDs connected to the switch or specified slot in Watts. None of the power budget on a specified slot can be used to power other slots or PDs on other slots. If you specify a slot that is not configured to hold a PoE module, the system returns the following error message: Error: Slot 2 is not capable of inline-power. You can modify the power budget without disabling the switch or slot. If the power consumption of the PDs on the switch or a specified slot exceeds this configured power budget, the system disconnects the lowest priority ports. (Refer to configure inline-power priority ports for information on configuring this parameter.) If you attempt to configure this power budget for a value that the system cannot safely provide, the system returns an error message. To display inline power settings, use the command show inline-power; to display the power for the entire switch, use the command show power budget. Note: You must disable inline power for the switch or the specified slot using the disable inline-power slot command prior to setting the budget to 0. To reduce the chances of ports fluctuating between powered and non-powered states, newly inserted PDs are not powered when the actual delivered power for the module is within approximately 19 W of the configured inline power budget for that switch or slot. However, actual aggregate power can be delivered up to the configured inline power budget for the switch or slot (for example, when delivered power from ports increases or when the configured inline power budget for the switch or slot is reduced). Example The following command sets the power for slot 4 to 150 W on NETGEAR 8800 switches: configure inline-power budget 150 slot 4 configure inline-power disconnect-precedence configure inline-power disconnect-precedence [deny-port | lowest-priority] 302 | Chapter 7. PoE Commands