Netgear XCM8810 Chassis Hardware Installation Guide - Page 214
con sharing lacp timeout
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
NETGEAR 8800 Chassis Switch CLI Manual To verify the LACP system priority, use the show lacp command. To change the system priority you previously assigned to a specific LAG, issue the configure sharing lacp system-priority using the new priority you want. To remove the assigned system priority entirely and use the LACP priorities, issue the configure sharing lacp system-priority using a value of 0. Example The following command assigns LAG 10 an LACP system priority of 3: configure sharing 10 lacp system-priority 3 configure sharing lacp timeout configure sharing lacp timeout [long | short] Description Configures the timeout used by each LAG to stop transmitting once LACPDUs are no longer received from the partner link. You can configure this timeout value to be either 90 seconds, long, or 3 seconds, short. Syntax Description port long short Specifies the master logical port for the LAG you are setting the timeout value for. Enter this value to use 90 seconds as the timeout value. Enter this value to use 3 seconds as the timeout value. Default Long. Usage Guidelines You must enable sharing and create the LAG prior to assigning this LACP timeout value. To verify the LACP timeout value, use the show lacp lag detail command. If you attempt to enter a port number that is different that a LAG group ID, the system returns the following error message: ERROR: LAG group Id does not exist Example The following command changes the timeout value for the specified LAG group ID to short: configure sharing 5:1 lacp timeout short 214 | Chapter 5. Commands for Configuring Slots and Ports on a Switch