Netgear XCM8810 Chassis Hardware Installation Guide - Page 313
enable inline-power legacy slot, enable inline-power ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 313 highlights
NETGEAR 8800 Chassis Switch CLI Manual enable inline-power legacy enable inline-power legacy slot enable inline-power legacy slot Description Enables non-standard (or capacitance) power detection mechanism for the specified slot on the switch. Syntax Description slot Enables non-standard power detection for specified slot. Default Disable. Usage Guidelines This command enables the non-standard power-detection mechanism on the specified slot. Legacy PDs do not conform to the IEEE 802.3af standard but may be detected by the switch through a capacitance measurement. However, measuring the power through capacitance is used only if this parameter is enabled and after an unsuccessful attempt to discover the PD using the standard resistance measurement method. The default for legacy is disabled. CAUTION: A normal (non-PoE) device may have a capacitance signature that causes the device to be detected as a legacy PoE device (and have power supplied), potentially causing damage to the device. On stack, if you do not specify a slot number, the command operates on all active nodes. The command operates only on nodes in the active topology. Example The following command enables capacitance detection of PDs on slot 3 on the switch: enable inline-power legacy slot 3 enable inline-power ports enable inline-power ports [all | ] Chapter 7. PoE Commands | 313