Netgear XCM8810 Chassis Hardware Installation Guide - Page 770
region status. You must use the dot1d encapsulation mode in an MSTP environment.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 770 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Adds one or more ports in a VLAN to a specified STPD. Syntax Description vlan_name all port_list tagged untagged stpd_name dot1d emistp pvst-plus Specifies a VLAN name. Specifies all of the ports to be included in the STPD. Specifies the port or ports to be included in the STPD. Specifies the ports should be configured as tagged. Specifies the ports should be configured as untagged. Specifies an STPD name on the switch. Specifies the STP encapsulation mode of operation to be 802.1d. Specifies the STP encapsulation mode of operation to be EMISTP. Specifies the STP encapsulation mode of operation to be PVST+. Default Ports in the default STPD (s0) are in dot1.d mode. Ports in user-created STPDs are in emistp mode. Usage Guidelines To create a VLAN, use the create vlan command. To create an STP domain, use the create stpd command. In an EMISTP or PVST+ environment, this command adds a list of ports to a VLAN and a specified STPD at the same time provided the carrier VLAN already exists on the same set of ports. You can also specify the encapsulation mode for those ports. In an MSTP environment, you do not need a carrier VLAN. A CIST controls the connectivity of interconnecting MSTP regions and sends BPDUs across the regions to communicate region status. You must use the dot1d encapsulation mode in an MSTP environment. You cannot configure STP on the following ports: • Mirroring target ports • Software-controlled redundant ports If you see an error similar to the following: Error: Cannot add VLAN default port 3:5 to STP domain You might be attempting to add: • A carrier VLAN port to a different STP domain than the carrier VLAN belongs 770 | Chapter 17. STP Commands