Netgear XCM8810 Chassis Hardware Installation Guide - Page 211

NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines This disables/enables monitoring on a particular member port. When monitoring is disabled, the member port is added back to the LAG if it has not already been added. This allows a member port to be added back to LAG even though connectivity to the host is down. Example The following command disables port 12: configure sharing health-check member-port 12 disable tcp-tracking configure sharing lacp activity-mode configure sharing lacp activity-mode [active | passive] Description Configures the whether the switch sends LACPDUs periodically (active) or only in response to LACPDUs sent from the partner on the link (passive). Syntax Description port active passive Specifies the master logical port for the LAG you are setting the activity mode for. Enter this value to have the switch periodically sent LACPDUs for this LAG. Enter this value to have the switch only respond to LACPDUs for this LAG. Default Active. Usage Guidelines You must enable sharing and create the LAG prior to assigning this LACP activity mode. Note: One side of the link must be in active mode in order to pass traffic. If you configure your side in the passive mode, ensure that the partner link is in LACP active mode. To verify the LACP activity mode, use the show lacp lag detail command. If you attempt to enter a port number that is different that a LAG group ID, the system returns the following error message: ERROR: LAG group Id does not exist Chapter 5. Commands for Configuring Slots and Ports on a Switch | 211