Netgear XCM8810 Chassis Hardware Installation Guide - Page 1056
con ospfv3 metric-table
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1056 highlights
NETGEAR 8800 Chassis Switch CLI Manual Note: The wait interval for the interface is not separately configurable. It is always equal to the dead interval. Example The following command sets the timers for the VLAN corporate: configure ospfv3 domain ospf-default vlan corporate timer retransmit-interval 10 transit-delay 2 hello-interval 20 dead-interval 80 configure ospfv3 metric-table configure ospfv3 {domain } metric-table 10M 100M 1G {10G } Description Configures the automatic interface costs for 10 Mbps, 100 Mbps, and 1 Gbps interfaces, and optionally, the 10 Gbps interface. Syntax Description domainName cost_x Specifies an OSPFv3 domain. OSPF-Default is the only one currently supported. Specifies the interface cost for the indicated interfaces. Range is 1 to 65535. Default • 10 Mbps-The default cost is 100. • 100 Mbps-The default cost is 50. • 1 Gbps-The default cost is 40. • 10 Gbps-The default cost is 20. Usage Guidelines The value of the costs cannot be greater for higher speed interfaces. In other words, the following condition must be true: cost_10m >= cost_100m >= cost_1g >= cost_10g Example The following command configures the automatic interface costs for 10 Mbps, 100 Mbps, and 1 Gbps interfaces: configure ospfv3 metric-table 10m 200 100m 100 1g 20 1056 | Chapter 24. OSPFv3 Commands