Netgear XCM8810 Chassis Hardware Installation Guide - Page 223
enable flow-control rx-pause ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
NETGEAR 8800 Chassis Switch CLI Manual Syntax Description port_list all Specifies one or more ports or slots and ports. Specifies all ports on the switch. Default Enabled. Usage Guidelines Use this command to stop receiving SNMP trap messages when a port transitions between being up and down. Example The following command stops ports 3, 5, and 12 through 15 on a stand-alone switch from receiving SNMP trap messages when the port goes up/down: disable snmp traps port-up-down ports 3,5,12-15 enable flow-control rx-pause ports enable flow-control rx-pause ports [ | all] Description Enables the switch to process received pause frames. Syntax Description port_list Specifies one or more ports or slots and ports. Default Enabled Usage Guidelines Use this command to configure the switch to return to the default behavior of processing received pause frames. Example The following command enables the tx flow-control feature on ports 5 through 7 on a NETGEAR 8800: enable flow-control rx-pause ports 5-7 Chapter 5. Commands for Configuring Slots and Ports on a Switch | 223