Netgear XCM8810 Chassis Hardware Installation Guide - Page 1228
show iproute multicast, vr_name is the VR of the current CLI context.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1228 highlights
NETGEAR 8800 Chassis Switch CLI Manual 44.66.0.0/16 30.30.30.1 0 U- None pc5-3 Flags: (*) Active, (G) Gateway, (U) Up Mask distribution: 1 default routes 2 routes at length 8 4 routes at length 16 1 routes at length 24 2 routes at length 32 Total number of multicast static routes = 10 show iproute multicast show iproute {ipv4} {{vlan} | [ | ] | origin [direct | static | mbgp | imbgp | embgp]} multicast {vr } Description Displays all or a filtered set of multicast routes in the IP multicast routing table. Syntax Description ipv4 name ipaddress netmask ipNetmask origin v_name Selects only IPv4 multicast routes. Specifies a VLAN for which to display multicast routes. Specifies an IP address and network mask (in dotted decimal notation) for which to display multicast routes. Specifies the IP address and network mask in classless inter domain routing (CIDR) notation. Limits the displayed multicast routes to those generated by the specified origin. Origin options select direct routes, static routes, and routes created by the MBGP, IMBGP, and EMBGP protocols. Specifies the virtual router for which to display multicast routes. Default vr_name is the VR of the current CLI context. Usage Guidelines This command does not display unicast routes, which can be used for multicast traffic. Example The following example displays all the routes in multicast routing table: # show iproute multicast Ori Destination Gateway @d 3.3.3.3/32 3.3.3.3 Mtr Flags VLAN 1 U-------m--- lpbk Duration 12d:1h:30m:36s 1228 | Chapter 26. IP Multicast Commands