Netgear XCM8810 Chassis Hardware Installation Guide - Page 1307
Appendix A., Configuration and Image Commands, NETGEAR 8800 Chassis Switch CLI Manual, available
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1307 highlights
NETGEAR 8800 Chassis Switch CLI Manual Syntax Description auto-install install-on-demand Specifies NETGEAR 8800 to automatically upgrade the firmware if the software detects a newer firmware image is available. The switch does not prompt you to confirm the firmware upgrade. Specifies the switch to prompt you to upgrade the firmware when the NETGEAR 8800 determines that a newer firmware image is available. This is the default behavior. Default The default is install-on-demand. Usage Guidelines Use the configure firmware [auto-install | install-on-demand] and install firmware {force} commands to upgrade the BootROM images on the MSM and I/O modules and the firmware on the PSU controllers installed in a NETGEAR 8800 series switch. Firmware images are bundled with NETGEAR 8800 software images. NETGEAR 8800 automatically compares the existing firmware image flashed into the hardware with the firmware image bundled with the NETGEAR 8800 image when you: • Download a new version of firmware to the alternate (inactive) partition. • Install a new module into an active chassis. After a firmware image upgrade, messages are sent to the log. If you select the auto-install parameter, you are not prompted to confirm the firmware upgrade. Whenever NETGEAR 8800 determines a newer firmware image is available, the firmware is automatically upgraded. If you use the default configuration install-on-demand, you have the opportunity to cancel the firmware upgrade. If you install a new software image, and a new firmware image is available, the switch prompts you to upgrade the firmware. Enter y to upgrade the firmware image. Enter n to cancel the firmware upgrade for the specified hardware and continue scanning for other hardware that needs to be upgraded. The following command downloads the switch software image. The secondary partition must be the alternate partition. download image NG8800-12.4.3.5-1-4.xos secondary If you download a new image and new firmware images are available, you see messages similar to the following: Do you want to install image after downloading? (y - yes, n - no, - cancel) Yes Downloading to MSM-A Saving configuration on secondary MSM done! Appendix A. Configuration and Image Commands | 1307