Netgear XCM8810 Chassis Hardware Installation Guide - Page 314
enable inline-power slot
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 314 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Enables PoE power currently provided to all ports or to specified ports. Syntax Description all port_list Enables inline power to all ports on the switch. Enables inline power to the specified ports. Default Enable. Usage Guidelines Disabling inline power to a port immediately removes power to any connected PD. By default, inline power provided to all ports is enabled. To deliver inline power to ports with connected PDs, you must also reserve power for the slot with the PDs using the configure inline-power budget command. If you do not have enough reserved power for the port, that port moves into a Denied state. Note: If your chassis has an inline power module and there is not enough power to supply a slot, that slot will not be powered on; the slot will not function in data-only mode without enough power for inline power. Disabling inline power using the disable inline-power command does not affect the data traffic traversing the port. And, disabling the port using the disable port command does not affect the inline power supplied to the port. Example The following command enables inline power to ports 4 and 5 on slot 3 on the switch: enable inline-power ports 3:4-5 enable inline-power slot enable inline-power slot Description Enables PoE power to the specified slot on the switch. 314 | Chapter 7. PoE Commands