Netgear XCM8810 Chassis Hardware Installation Guide - Page 1270
Defaults, Usage Guidelines, Example, Description, Syntax Description, con msdp peer sa-filter
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1270 highlights
NETGEAR 8800 Chassis Switch CLI Manual tcpPassword vrname Specifies the password to use for MD5 authentication at the TCP level. The password must be an ASCII string with a maximum of 31 characters. Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Defaults By default, TCP MD5 authentication is disabled for the MSDP peer. Usage Guidelines NETGEAR recommends that you enable TCP MD5 authentication for all MSDP peers to protect MSDP sessions from attacks. You can execute this command only when the MSDP peer is disabled or when MSDP is globally disabled on that VR. Example The following command configures a password for the MSDP peer with the IP address 192.168.45.43, which automatically enables TCP MD5 authentication: configure msdp peer 192.168.45.43 password test123 The following command removes the password: configure msdp peer 192.168.45.43 password none configure msdp peer sa-filter configure msdp peer [ | all] sa-filter [in | out] [ | none] {vr } Description This command configures an incoming or outgoing policy filter for SA messages. Syntax Description filter-name in out peer all remoteaddr vrname Specifies the name of the policy associated with an SA filter. To remove an SA filter, enter the "none" CLI keyword for . Associates the SA filter with inbound SA messages. Associates the SA filter with outbound SA messages. Specifies all MSDP peers. Specifies the IP address of the MSDP peer. Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. 1270 | Chapter 28. MSDP Commands