Netgear XCM8810 Chassis Hardware Installation Guide - Page 924
con tunnel ipaddress, create tunnel 6to4, source address of the endpoint, in hexadecimal
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 924 highlights
NETGEAR 8800 Chassis Switch CLI Manual determination. The maximum value is a 4,294,967,295. The default value is 2,592,000 seconds (30 days). Example The following command sets the on link parameter of the prefix 3aaa:3161::/64 to off, for the VLAN top_floor: configure vlan top_floor router-discovery set prefix 3aaa:3161::/64 onlink-flag off configure tunnel ipaddress configure tunnel ipaddress [ipv6-link-local | {eui64} ] Description Configures an IPv6 address/prefix on a tunnel. Syntax Description tunnel_name eui64 ipv6_address_mask ipv6-link-local Specifies an IPv6 tunnel. Specifies an EUI64 interface identifier for the lower 64 bits of the address. Specifies an IPv6 address / IPv6 prefix length. Specifies the link-local address for a tunnel. Default N/A. Usage Guidelines This command will configure an IPv6 address/prefix route on the specified tunnel. 6to4 tunnels must follow the standard address requirement. The address must be of the form 2002:::/16, where is replaced by the IPv4 source address of the endpoint, in hexadecimal, colon separated form. For example, for a tunnel endpoint located at IPv4 address 10.20.30.40, the tunnel address would be 2002:a14:1e28::/16. In hex, 10 is a, 20 is 14, 30 is 1e and 40 is 28. 6in4 tunnels have no restrictions on their address format or prefix allocations. Example The following command configures the 6in4 tunnel link39 with the IPv6 link-local address: configure tunnel link39 ipaddress ipv6-link-local create tunnel 6to4 create tunnel 6to4 source 924 | Chapter 20. IPv6 Unicast Commands