Netgear XCM8810 Chassis Hardware Installation Guide - Page 204
con ports redundant, The following command con s the user-defined string
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines The display string can be up to 15 characters. Display strings do not need to be unique for each port-you can assign the same string to multiple ports. For example, you could give all the ports that connected to a particular department a common display string. The string is displayed in certain commands such as the show ports information command. Note: Do not use a port number as a display string. For example, do not assign the display string "2" to port 2. Example The following command configures the user-defined string corporate for port 1 on a stand-alone switch: configure ports 1 display-string corporate The following command configures the user-defined string corporate for ports 3, 4, and 5 on slot 1: configure ports 1:3-5 display-string corporate configure ports redundant configure ports redundant {link [on | off]} Description Configures a software-controlled redundant port. Syntax Description primaryPort redundantPort link Specifies one primary port or slot and port. Specifies one or redundant port or slot and port. Specifies state of link: • on-Specifies keeping the redundant port active, but block traffic • off-Specifies forcing the link down on the redundant port Note: The default value is off. Default N/A. 204 | Chapter 5. Commands for Configuring Slots and Ports on a Switch