Netgear XCM8810 Chassis Hardware Installation Guide - Page 828
con ipforwarding originated-packets, con iproute add IPv4
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 828 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command sets the IP ARP timeout period to 10 minutes: configure iparp timeout 10 configure ipforwarding originated-packets configure ipforwarding originated-packets [ require-ipforwarding | dont-require-ipforwarding ] Description Configures the ipforwarding behavior. Syntax Description This command has no arguments or variables. Default dont-rquire-ipforwarding. Usage Guidelines You can configure IP forwarding to be either required or not required. Example The following command configures required ipforwarding: configure ipforwarding originated-packets require-ipforwarding configure iproute add (IPv4) configure iproute add [ | ] {metric} {multicast | multicast-only | unicast | unicast-only} {vr } Description Adds a static route to the specified routing table. Syntax Description ipNetmask ip_addr mask gateway metric Specifies an IP address/mask length. Specifies an IP address. Specifies a subnet mask. Specifies a gateway IP address. Specifies a cost metric. 828 | Chapter 19. IP Unicast Commands