Netgear XCM8810 Chassis Hardware Installation Guide - Page 377
disable sys-health-check, To return to the default interval of 5 seconds
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 377 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command disables sFlow sampling on port 3:1: disable sflow ports 3:1 disable sys-health-check disable sys-health-check slot Description Discontinues sending backplane diagnostic packets. Syntax Description slot Specifies the slot to disable sending backplane diagnostic packets. Default Polling is enabled, backplane diagnostic packets are disabled. Depending upon your platform, when disabling backplane diagnostic packets, note that by default the system health checker discontinues sending backplane diagnostic packets to the specified slot. Only polling is enabled. Usage Guidelines When you use this command, backplane diagnostic packets are disabled and no longer sent by the system health checker. If you modify the interval in the configure sys-health-check interval command and later disable backplane diagnostics, the configured interval for sending backplane diagnostic packets remains. The next time you enable backplane diagnostic packets, the health checker sends backplane diagnostics packets at the configured interval. For example, if you configure an interval of 8 seconds, the system health checker sends backplane diagnostic packets every 8 seconds. To return to the "default" interval of 5 seconds, configure the frequency of sending backplane diagnostic packets to 5 seconds using the following command: configure sys-health-check interval 5 Example On the NETGEAR 8800 series switches, the following example assumes that you did not modify the interval option in the configure sys-health-check interval command. The following command disables backplane diagnostics on slot 3, polling is always enabled and occurs every 5 seconds. Chapter 8. Commands for Status Monitoring and Statistics | 377