Netgear XCM8810 Chassis Hardware Installation Guide - Page 333

NETGEAR 8800 Chassis Switch CLI Manual clear log clear log {error-led | static | messages [memory-buffer | nvram]} Description Clears the log messages in memory and NVRAM, and clears the ERR LED on the MSM/MM. Syntax Description error-led static memory-buffer nvram Clears the ERR LED on the MSM/MM. Specifies that the messages in the NVRAM and memory-buffer targets are cleared, and the ERR LED on the MSM/MM is cleared. Clears entries from the memory buffer. Clears entries from NVRAM. Default N/A. Usage Guidelines The switch log tracks configuration and fault information pertaining to the device. By default, log entries that are sent to the NVRAM remain in the log after a switch reboot. The clear log and clear log messages memory-buffer commands remove entries in the memory buffer target; the clear log static and clear log messages nvram commands remove messages from the NVRAM target. In addition, the clear log static command will also clear the memory buffer target. There are three ways to clear the ERR LED: clear the log, reboot the switch, or use the clear log error-led command. To clear the ERR LED without rebooting the switch or clearing the log messages, use the clear log error-led command. Example The following command clears all log messages, from the NVRAM: clear log static clear log counters clear log counters [ | [all | ] {severity {only}}] Description Clears the incident counters for events. Chapter 8. Commands for Status Monitoring and Statistics | 333