Netgear XCM8810 Chassis Hardware Installation Guide - Page 930
enable iproute ipv6 compression
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 930 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Enables IP routing VLANs. If no argument is provided, enables IP routing for all VLANs and tunnels that have been configured with an IPv6 address on the current virtual router. Syntax Description vlan_name tunnel_name vr_name Specifies an IPv6 configured VLAN. Specifies an IPv6 tunnel. Specifies a virtual router. Default Disabled. Usage Guidelines When new IPv6 interfaces are added, IP forwarding is disabled by default. NETGEAR switches have a single hardware control per VLAN for IP forwarding of IPv4 and IPv6 unicast packets. Therefore, enabling IPv6 forwarding on a VLAN also enables IPv4 hardware forwarding on that VLAN. Example The following command enables forwarding of IPv6 traffic for all VLANs in the current virtual router context with IPv6 addresses: enable ipforwarding ipv6 enable iproute ipv6 compression enable iproute ipv6 compression {vr } Description This command enables IPv6 route compression. Syntax Description vrname Specifies the virtual router to route from. Default Vrname-current CLI context VR 930 | Chapter 20. IPv6 Unicast Commands