Netgear XCM8810 Chassis Hardware Installation Guide - Page 30

NETGEAR 8800 Chassis Switch CLI Manual Default The default time-out is 20 minutes. Usage Guidelines This command configures the length of time the switch will wait before disconnecting idle console, SSH2, or Telnet sessions. The idletimeout feature must be enabled for this command to have an effect (the idletimeout feature is enabled by default). Example The following command sets the time-out for idle login and console sessions to 10 minutes: configure idletimeout 10 configure safe-default-script configure safe-default-script Description Allows you to change management access to your device and to enhance security. Syntax Description This command has no arguments or variables. Default N/A. Usage Guidelines This command runs an interactive script that prompts you to choose to enable or disable SNMP, Telnet, and enabled ports. Refer to the "Safe Defaults Setup Method" section in the NETGEAR 8800 User Manual for complete information on the safe default mode. Once you issue this command, the system presents you with the following interactive script: Telnet is enabled by default. Telnet is unencrypted and has been the target of security exploits in the past. Would you like to disable Telnet? [y/N]: SNMP access is enabled by default. SNMP uses no encryption, SNMPv3 can be configured to eliminate this problem. Would you like to disable SNMP? [y/N]: All ports are enabled by default. In some secure applications, it maybe more 30 | Chapter 2. Commands for Accessing the Switch