Netgear XCM8810 Chassis Hardware Installation Guide - Page 751

NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines If your STPD has the same name as another component, for example a VLAN, NETGEAR recommends that you specify the identifying keyword as well as the name. If your STPD has a name unique only to that STPD, the keywords stpd and vlan are optional. In EMISTP and PVST+ environments, if the specified VLAN is the carrier VLAN, all protected VLANs on the same set of ports are also removed from the STPD. You also use this command to remove autobind ports from a VLAN. The NETGEAR 8800 records the deleted ports so that the ports are not automatically added to the STPD after a system restart. When a port is deleted on the MSTI, it is automatically deleted on the CIST as well. Example The following command removes all ports of a VLAN named Marketing from the STPD STPD1: configure stpd stpd1 delete vlan marketing ports all configure stpd forwarddelay configure stpd forwarddelay Description Specifies the time (in seconds) that the ports in this STPD spend in the listening and learning states when the switch is the root bridge. Syntax Description stpd_name seconds Specifies an STPD name on the switch. Specifies the forward delay time in seconds. The default is 15 seconds, and the range is 4 to 30 seconds. Default The default forward delay time is 15 seconds. Usage Guidelines If your STPD has the same name as another component, for example a VLAN, NETGEAR recommends that you specify the identifying keyword as well as the name. If your STPD has a name unique only to that STPD, the keyword stpd is optional. Chapter 17. STP Commands | 751