Netgear XCM8810 Chassis Hardware Installation Guide - Page 695
Example, Description, Syntax Description, Default, Usage Guidelines, Enabling Dynamic Network Login VLANs
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 695 highlights
NETGEAR 8800 Chassis Switch CLI Manual show netlogin The switch displays the current state of dynamic VLAN creation (enabled or disabled) and the uplink port(s) associated with the dynamic VLAN. Example The following command automatically adds ports 1:1-1:2 to the dynamically created VLAN as uplink ports: configure netlogin dynamic-vlan uplink-ports 1:1-1:2 configure netlogin dynamic-vlan uplink-ports configure netlogin dynamic-vlan uplink-ports [ | none] Description Specifies which port(s) are added as tagged, uplink ports to the dynamically created VLANs for network login. Syntax Description port_list none Specifies one or more ports to add to the dynamically created VLAN for network login. Specifies that no ports are added. This is the default setting. Default The default setting is none. Usage Guidelines Use this command to specify which port(s) are used as uplink ports and added to the dynamically created VLAN for network login. The uplink ports send traffic to and from the supplicants from the core of the network. Uplink ports should not be configured for network login (network login is disabled on uplink ports). If you specify an uplink port with network login enabled, the configuration fails and the switch displays an error message similar to the following: ERROR: The following ports have NetLogin enabled: 1, 2 If this occurs, select a port with network login disabled. Enabling Dynamic Network Login VLANs To configure the switch to dynamically create a VLAN upon receiving an authentication response, use the following command: configure netlogin dynamic-vlan [disable | enable] Chapter 16. Network Login Commands | 695