Netgear XCM8810 Chassis Hardware Installation Guide - Page 107
enable snmpv3, enable sntp-client
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
NETGEAR 8800 Chassis Switch CLI Manual To view if SNMP traps are being sent from the switch, use the show management command. The show management command displays information about the switch including the enabled/disabled state of SNMP traps being sent. Example The following command enables SNMP trap support on the switch: enable snmp traps enable snmpv3 enable snmpv3 [default-group | default-user] Description Selectively enables SNMPv3 default-group or default-user access on the switch. Syntax Description default-group default-user Specifies SNMPv3 default-group. Specifies SNMPv3 default-user. Default Enabled Usage Guidelines This command is used to enable SNMPv3 default-group or default-user access. Enabling SNMPv3 default-group access activates the access to an SNMPv3 default-group and the user- created SNMPv3-user part of default-group. Enabling the SNMPv3 default-user access allows an end user to access the MIBs using SNMPv3 default-user. This command throws an error if the SNMPv3 access is disabled on the switch. The default groups are: admin, initial, v1v2c_ro, v1v2c_rw. The default users are: admin, initial, initialmd5, initialsha, initialmd5Priv, initialshaPriv. Example The following command enables the default users on the switch: enable snmp default-user enable sntp-client enable sntp-client Chapter 3. Commands for Managing the Switch | 107